Brake Cable Equalization; Final Brake Cluster Adjustment - Club Car Turf 252 2007 Maintenance And Service Manual

WHEEL BRAKE ASSEMBLIES

BRAKE CABLE EQUALIZATION

1. Set park brake in the third tooth of the ratchet. Place a wedge between the park brake pedal and brake pedal to
prevent the park brake from disengaging while equalizing the brake cables (Figure 6-19, Page 6-11).
2. Equalize the brake cables.
2.1. Four-wheel brake vehicles only: Tighten the nylon lock nut (6) on the front equalizer rod (2) to 35 in-lb (4
N·m) (Figure 6-14, Page 6-7).
2.2. Tighten the jam nut (5) on the rear equalizer rod (2) clockwise to 35 in-lb (4 N·m) (Figure 6-13, Page 6-7).
2.3. Repeat steps 2.1 and 2.2 until the nuts remain on the torque setting.
2.4. Hold the lock nut (6) on the front equalizer rod (2) in place with a wrench and tighten the jam nut (1) to 13
ft-lb (17.6 N·m) (Figure 6-14, Page 6-7).
2.5. Hold the jam nut (5) on the rear equalizer rod (2) in place with a wrench and tighten the lock nut (1) to 13
ft-lb (17.6 N·m) (Figure 6-13, Page 6-7). See following CAUTION.
CAUTION
• If the brake pedal return spring (6) was disconnected while equalizing the brake cables, be sure to
reconnect it before proceeding (Figure 6-13, Page 6-7).

FINAL BRAKE CLUSTER ADJUSTMENT

1. To adjust the brake shoes, turn the adjustment bolt counterclockwise five clicks.
2. Repeat step 1 at other brake cluster(s).
3. Install the rubber dust covers (4) over the brake adjustment bolts (5) (Figure 6-15, Page 6-8 and Figure 6-16,
Page 6-8).
4. Carefully support the vehicle with the lifting device, remove jack stands and lower the vehicle to the ground.
5. Connect the battery cables. See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3. See
Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
Figure 6-19 Set Park Brake and Insert Wedge
Brake Adjustment (Manually-Adjusted Brakes)
6
Page 6-11