Fuse; Fuse Removal; Fuse Installation; Kill Limit Switch - Club Car Turf 252 2007 Maintenance And Service Manual

14

Fuse

FUSE
See General Warning on page 1-1.
TESTING THE FUSE
See Test Procedure 2 – Fuse on page 12-12.

FUSE REMOVAL

1. Disconnect battery. See Disconnecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
2. Remove electrical component box cover.
3. Remove the fuse from the fuse block.

FUSE INSTALLATION

1. Install the fuse. See following WARNING.
WARNING
• If a fuse is blown, determine the cause of the failure and make necessary repairs before installing a
new fuse. Use the appropriately rated fuse; if a fuse with a higher amp rating is used, damage to the
vehicle electrical system may occur.
2. Install the snap-on electrical box cover by pressing down firmly on all corners and install the screw, tightening to
18 in-lb (2 N·m).
3. Connect battery. See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.

KILL LIMIT SWITCH

See General Warning on page 1-1.
TESTING THE KILL LIMIT SWITCH
See Test Procedure 16 – Kill Limit Switch on page 12-29.

KILL LIMIT SWITCH REMOVAL

1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section
1, Page 1-3.
2. Remove electrical component box cover (1) (Figure 14-18, Page 14-17).
3. Remove the two nuts (9) and washers (10) securing the accelerator pedal limit switch (11). Do not disconnect the
wires attached to switch (11) (Figure 14-18, Page 14-17).
Page 14-16 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
ELECTRICAL COMPONENTS: PEDAL-
START GAS VEHICLE