S10 FE 350 ENGINE
1
6
530
Figure 15-6 Crankcase Cover Installation
IGNITION COIL AND FLYWHEEL
See General Warning on page 1-1.
IGNITION COIL AND FLYWHEEL REMOVAL
1.
Loosen three screws (2) and remove the remaining four screws (1) attaching the flywheel housing as shown,
then remove the housing (Figure 15-7, Page 15-7).
2.
Disconnect the ignition coil (11) from its primary lead wire at the connector (12). Remove the two bolts (10) and
take out the ignition coil (Figure 15-8, Page 15-7).
1
531
Figure 15-7 Flywheel Housing
3.
Hold the flywheel (4), not the fan (7), with a strap wrench (5) and, using a 25 mm socket, remove the flywheel nut
(and flat washer) by turning it counterclockwise (Figure 15-9, Page 15-8). See following CAUTION.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
7
2
4
13
1
11
510
Ignition Coil and Flywheel
12
Figure 15-8 Ignition Coil
15
10
Page 15-7