Table of Contents
Advertisement
18
Choke and Air Intake System
CHOKE CABLE REMOVAL
1.
Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
2.
Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section
1, Page 1-3.
3.
Remove the screw (17) securing cable to air box and detach cable end from choke lever (6) (Figure 18-11,
Page 18-13) .
4.
Remove three screws (19), nuts (21) and washers (20) from body and remove choke cable assembly from
body (Figure 18-11, Page 18-13).
CHOKE CABLE INSTALLATION
1.
Insert choke cable through hole in body until choke lever assembly seats against body.
2.
Install three screws (19), washers (20), and lock nuts (21) as shown and tighten to 18 in-lb (2.0 N·m) (Figure
18-11, Page 18-13).
3.
Check the hex nut on the cable at the back of the choke lever assembly. If it is loose, tighten it until the lock
washer beside it collapses completely.
4.
Attach choke cable to choke lever (6) on air box. Install screw (17) to secure cable to air box and tighten to 18
in-lb (2.0 N·m) (Figure 18-11, Page 18-13).
5.
Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
Page 18-12
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
S27 FE 350 FUEL SYSTEM
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
