Monitor Menu; Speed In; Throttle; Batt Voltage - Club Car Turf 252 2007 Maintenance And Service Manual

23

Monitor Menu

Information
The information menu displays the model number, serial number, manufacturer date and software version of the speed
controller. See Information on page 23-18.
Programmer Setup
The programmer setup menu allows the user to set the LCD contrast, display the fault history of the programmer as
well as various other information pertaining to the handset such as model number, serial number, OEM information,
etc. See Programmer Setup on page 23-18.
MONITOR MENU
The monitor menu is accessed by using the up or down arrow to scroll to monitor and pressing the right arrow key
to activate the menu. All information in the monitor menu is updated in real time, allowing the trained technician to
troubleshoot the vehicle by monitoring the handset as the key switch is cycled, Forward/Reverse switch is activated, etc.
Since the monitor menu is updated while the vehicle is in operation, the trained technician has the ability to monitor
the status of several components in conditions or locations where a problem with vehicle performance has been
reported. See following WARNING.
WARNING
• The vehicle operator should not monitor the handset while the vehicle is in motion. A technician
can monitor the handset while traveling as a passenger in the vehicle. Failure to heed this warning
could result in severe personal injury or death.
The following parameters can be monitored in real time with the handset from the monitor menu:

SPEED IN

Indicates the approximate ground speed of the vehicle in miles per hour (MPH).

THROTTLE %

Indicates the position of the accelerator pedal from 0% (pedal not pressed) to 95 - 100% (pedal fully pressed). This
item can be monitored when the key switch is in the ON or OFF position.

BATT VOLTAGE

Displays the current battery voltage at the speed controller.

HEATSINK TEMP

Displays the temperature (in degrees Celsius) of the speed controller heatsink. During normal operating conditions, the
heatsink temperature should be below 85 °C ±5 °C (185 °F ±9 °F). See following NOTE.
Page 23-4 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
IQ DISPLAY MODULE (IQDM) SERIES 2
AND IQDM-P DIAGNOSTICS