Table of Contents
Advertisement
24
Battery Warning Light
RECEPTACLE FUSE LINK INSTALLATION
1.
Insert the two fuse link mounting posts into the mounting holes in the charger receptacle.
2.
Place the two 10-gauge black wires in their original positions on the fuse link mounting posts.
3.
Install nuts (7) on fuse link mounting posts and tighten to 23 in-lb (2.6 N·m) (Figure 24-11, Page 24-15).
4.
Connect the batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
BATTERY WARNING LIGHT
See General Warning on page 1-1.
TESTING THE BATTERY WARNING LIGHT
See Test Procedure 29 – Battery Warning Light on page 22-35.
BATTERY WARNING LIGHT REMOVAL
1.
Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2.
Remove center dash. See Key Switch Removal on page 24-1.
3.
Disconnect the brown wire at the quick disconnect terminal and remove the orange/white wire from the key switch.
4.
Press the two retaining tabs (11) and remove the light from the center dash (Figure 24-12, Page 24-17).
BATTERY WARNING LIGHT INSTALLATION
1.
Install in reverse order of removal.
2.
Connect the batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
Page 24-16
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
ELECTRICAL COMPONENTS: ELEC-
TRIC VEHICLES
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
