Motor Disassembly - Club Car Turf 252 2007 Maintenance And Service Manual

27
Motor
9. Remove the four bolts that mount the motor to the transaxle (Figure 27-20, Page 27-15). See following
CAUTION.
CAUTION
• Do not position fingers under motor when sliding motor off of the input shaft in step 9. Fingers may
get pinched when motor disengages.
10. Carefully slide the motor away from the transaxle until the motor spline disengages the input shaft and remove
the motor from the vehicle.
Figure 27-4 Speed Sensor Magnet

MOTOR DISASSEMBLY

1. Release the clasp and remove the headband assembly (21) from the motor. Visually inspect brushes and
springs. (Figure 27-13, Page 27-10).
2. Before continuing disassembly, place match marks on the motor end cap (20) and motor frame (14).
3. Remove speed sensor (10) and magnet (12).
3.1. Remove the two screws (11) that secure the speed sensor (10) to the end cap (20).
3.2. Remove the bolt (13) securing the magnet (12) to the armature shaft (15). Hold the back of the armature
assembly to keep it from turning as you remove the bolt.
3.3. Inspect the speed sensor magnet. See Speed Sensor Magnet Inspection on page 27-9.
Page 27-4 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
MOTOR (MODEL DA5-4006): ELECTRIC
Figure 27-5 End Cap Removal
VEHICLES