Changing The Main Jet - Club Car Turf 252 2007 Maintenance And Service Manual

S10 FE 350 FUEL SYSTEM
ALTITUDE
8000-10,000 ft. (2438.4-3048 m)
10,000 ft. and over (3048 m and over)

CHANGING THE MAIN JET

See General Warning on page 1-1.
1. Remove the carburetor.
1.1. Turn fuel shut-off valve on fuel tank to the closed (OFF) position (Figure 17-18, Page 17-26 or Figure
17-19, Page 17-26).
1.2. Loosen the intake air hose clamp (22) and disconnect the intake air hose (23) at the carburetor end only
(Figure 17-1, Page 17-2).
1.3. Remove the governor guard (5).
1.4. Disconnect the governor cable (30) from the carburetor.
1.5. Disconnect the carburetor vent line (14).
1.6. Disconnect the fuel supply line (26) at the carburetor end only. Temporarily plug the end of the fuel line to
prevent fuel leakage.
1.7. Remove the carburetor retaining nuts (19), intake pipe (17), and carburetor (12). See following NOTE.
NOTE: Note the orientation of the gasket (16), between the carburetor intake pipe (17) and the carburetor body (12)
so that it can be replaced in the same orientation (Figure 17-1, Page 17-2).
When removing the carburetor body, the throttle return spring (11) must be disconnected. Note its proper
orientation so that it can be replaced in the same orientation.
The carburetor must be kept upright during removal.
2. Position the carburetor with the drain screw (11) over a catch basin (Figure 17-4, Page 17-4).
3. Turn the carburetor bowl drain screw counterclockwise two or three turns and drain all the fuel from the bowl
into the catch basin (Figure 17-2, Page 17-3). Tighten the drain screw to 10 in-lb (1.1 N·m). Return fuel to the
fuel tank or dispose of properly.
4. Mark the body of the carburetor and the carburetor fuel bowl with an indelible ink marker so that, after removal,
the bowl can be installed again in the same position (Figure 17-3, Page 17-3).
535
Figure 17-2 Drain Bowl
5. Remove the carburetor fuel bowl retaining screw and washer (12), then remove the fuel bowl (10) and clean it
with a nonflammable solvent (Figure 17-4, Page 17-4). See following NOTE.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
FE290 ENGINE MAIN JET SIZE
75
72
536
Figure 17-3 Mark Carburetor and Bowl for Alignment
Carburetor
FE350 ENGINE MAIN JET SIZE
78
75
Page 17-3
17