Table of Contents
Advertisement
24
Charger Receptacle
NOTE: Disassembly of the charger receptacle, for the purpose of removal or installation, is not recommended.
CHARGER RECEPTACLE REMOVAL
1.
Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2.
Remove the 10-gauge red wire from the connector plug (10) (Figure 24-11, Page 24-15).
3.
Remove black 10-gauge OBC wire from charger receptacle.
4.
Disconnect the gray wire from the receptacle at the yellow fuse holder (9).
5.
Remove the four screws (2) that secure the charger receptacle bevel to the receptacle backing plate (1) and to
the vehicle body.
6.
Move the receptacle assembly toward the front of the vehicle and tilt receptacle upwards in order for the
receptacle to pass through the hole in the vehicle body.
CHARGER RECEPTACLE INSTALLATION
1.
Insert the 10-gauge red wire and the 18-gauge gray wire through the hole in the vehicle body and the receptacle
backing plate (Figure 24-11, Page 24-15).
2.
Insert receptacle into vehicle body.
3.
Install the four screws (2) that secure the receptacle to the vehicle body and receptacle backing plate (1).
Tighten screws to 16 in-lb (1.8 N·m).
4.
Connect 18-gauge gray wire to yellow fuse holder (9). Make sure fuse (8) is installed in fuse holder.
5.
Connect the 10-gauge black wire to the receptacle fuse link on the charger receptacle. Tighten to 23 in-lb (2.6
N·m).
6.
Connect the 10-gauge red wire (10) to the connector plug.
7.
Connect the batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
Page 24-14
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
ELECTRICAL COMPONENTS: ELEC-
TRIC VEHICLES
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
