Table of Contents
Advertisement
ELECTRICAL COMPONENTS: ELECTRIC
VEHICLES
CIRCUIT BREAKER
See General Warning on page 1-1.
TESTING THE CIRCUIT BREAKER
See Test Procedure 7 – Circuit Breaker on page 22-17
CIRCUIT BREAKER REMOVAL
1.
Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2.
Remove the plastic nut (1) from the circuit breaker (Figure 24-4, Page 24-5).
3.
Remove circuit breaker and metal nut (2) from bracket (3).
4.
Disconnect tan and green wires from the spade connectors (4) on the back of the circuit breaker.
CIRCUIT BREAKER INSTALLATION
1.
Installation is reverse of removal. Connect tan and green wires to the spade connectors (4) on the back of
the circuit breaker. See following NOTE.
NOTE: The spade connectors are not polarity-sensitive. It does not matter what color wire goes to either of the
spade connectors.
2.
Insert the circuit breaker and metal nut (2) into the bracket (3).
3.
Replace the plactic nut (1) on the circuit breaker.
4.
Connect the batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
1
2
Figure 24-4 Circuit Breaker
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
4
24
Circuit Breaker
Page 24-5
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
