Key Switch; Key Switch Removal - Club Car Turf 252 2007 Maintenance And Service Manual

ELECTRICAL COMPONENTS: KEY-START WITH
NEUTRAL REV GAS VEHICLE

KEY SWITCH

See General Warning on page 1-1.
TESTING THE KEY SWITCH
See Test Procedure 4 – Key Switch (Starter Circuit) on page 11-14. Also see Test Procedure 17 – Key Switch
(Engine Kill Circuit) on page 11-28.

KEY SWITCH REMOVAL

1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section
1, Page 1-3.
2. Remove the center dash panel.
2.1. Remove the plastic cap (1) covering the mounting screw (2) on each side of the center dash panel (3)
(Figure 13-17, Page 13-17).
2.2. Loosen, but do not remove, the screw (2) on each side of the center dash panel (3).
2.3. Insert screwdriver at the top center of the dash between dash and cowl brace. Gently pry center dash out
slightly from under edge of cowl brace.
2.4. Pull center dash out from the frame and disconnect the wires from the electrical components mounted on
the dash panel. Do not allow wires to touch. See following NOTE.
NOTE: Take care to prevent key switch terminals and wires from touching the metal frame around the dash.
2.5. Slide center dash panel up the steering column.
516
3. Disconnect the wires from the key switch.
4. Remove the key switch:
4.1. Remove the key switch cap with a small, flat-blade screwdriver.
4.2. Remove key switch (2) from the dash by holding the key switch and turning the nut (1) on the outside of the
dash with a 1-inch socket wrench (Figure 13-18, Page 13-18). Remove the keyed washer with key switch.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
3
Figure 13-17 Center Dash Panel Removal
Key Switch
2
1
Page 13-17
13