Voltage Regulator Installation; Key Switch; Key Switch Removal - Club Car Turf 252 2007 Maintenance And Service Manual

ELECTRICAL COMPONENTS: PEDAL-START GAS
VEHICLE
1
9
1. Red wire to solenoid. 2. To kill limit switch. 3. To frame
ground. 4. To bullet connector.
500
Figure 14-15 Voltage Regulator

VOLTAGE REGULATOR INSTALLATION

1. Position the voltage regulator (9) in the electrical component box and install the mounting screw (8) (Figure
14-15, Page 14-13). Tighten screw to 23 in-lb (2.6 N·m).
2. Connect the voltage regulator red wire (1) at the large post on the solenoid, the yellow wire (4) at the bullet
connector, and the black wire (7) at the battery frame ground (Figure 14-15, Page 14-13).
3. Install snap-on electrical component box cover. Be sure to firmly press down all corners. Install screw and
tighten to 18 in-lb (2 N·m).
4. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
5. Place Forward/Reverse handle in NEUTRAL and place the neutral lockout switch in the MAINTENANCE position.
Start the engine and check regulator for proper functioning as described in the voltage regulator test procedure.
See Voltage Regulator on page 12-19.

KEY SWITCH

See General Warning on page 1-1.
TESTING THE KEY SWITCH
See Test Procedure 4 – Key Switch (Starter Circuit) on page 12-14.
See Test Procedure 17 – Key Switch (Engine Kill Circuit) on page 12-30.

KEY SWITCH REMOVAL

1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section
1, Page 1-3.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
2
3
14
Key Switch
Page 14-13