Oil Level Sensor - Club Car Turf 252 2007 Maintenance And Service Manual

16
Crankcase
5
4
525

OIL LEVEL SENSOR

Testing the Oil Level Sensor
See Oil Level Sensor on page 11-30.
Oil Level Sensor Removal
1. If not already removed, remove crankcase cover. See Crankcase Cover Removal on page 16-4.
2. Disconnect the oil level sensor wire (2) from the cord connection (1) (Figure 16-7, Page 16-7).
3. Remove the screw (3) from the wire clamp (4).
4. Remove the two mounting screws from the inside of the crankcase cover and remove the oil level sensor and
bracket.
5. If necessary, remove the three screws (7) that hold the sensor to the bracket (5).
Oil Level Sensor Installation
1. If the oil level sensor was removed from the bracket, install sensor (6) into bracket (5) and secure with three
screws (7) (Figure 16-7, Page 16-7). Tighten to 17 in-lb (1.9 N·m).
Page 16-6 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
2
1
Figure 16-6 Engine Mounting Plate
S27 FE 350 ENGINE
3
6