Rpm Limiter Installation - Club Car Turf 252 2007 Maintenance And Service Manual

ELECTRICAL COMPONENTS: PEDAL-START GAS
VEHICLE
5. Remove the flange head bolts (7) from the RPM limiter band (8) and remove the RPM limiter and damper
(9) (Figure 14-25, Page 14-25).
508

RPM LIMITER INSTALLATION

1. Place the RPM limiter (4) on the damper (9) squarely so that RPM limiter fits tightly against the damper.
2. Place the RPM limiter with damper on the front of the RPM limiter mounting bracket (10) (Figure 14-25, Page
14-25).
3. Place the band (8) over the RPM limiter and align the holes. Place the brown wire ring connector (11) onto the
flange head bolt (7) and secure the left side of the band. Use another flange head bolt to secure the other side of
the band. Make sure the band holds the RPM limiter securely in place. Tighten fasteners to 7 ft-lb (9.5 N·m).
4. Connect the black wire (2) to the white/black kill circuit wire (1) at the female bullet connector (3).
5. Connect the black wire (2) to the black wire (5) at the female bullet connector (6).
6. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
9
4
8
7
11
2
Figure 14-25 RPM Limiter Assembly
10
3
RPM Limiter
5
6
1
Page 14-25
14