Section 24 - Electrical Components: Electric Vehicles; Key Switch; Key Switch Removal - Club Car Turf 252 2007 Maintenance And Service Manual

SECTION 24 – ELECTRICAL COMPONENTS: ELECTRIC
VEHICLES
DANGER
• See General Warning on page 1-1.
WARNING
• See General Warning on page 1-1.

KEY SWITCH

See General Warning on page 1-1.
TESTING THE KEY SWITCH
See Test Procedure 9 – Key Switch and MCOR Limit Switch Circuit on page 22-18.

KEY SWITCH REMOVAL

1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2. Remove the center dash panel (Figure 24-1, Page 24-2).
2.1. Remove the plastic cap (1) covering the mounting screw (2) on each side of the center dash panel
(3) (Figure 24-1, Page 24-2).
2.2. Loosen, but do not remove, the screw (2) on each side of the center dash panel (3).
2.3. Insert screwdriver at the top center of the dash between dash and cowl brace. Gently pry center dash out
slightly from under edge of cowl brace.
2.4. Pull center dash out from the frame and disconnect the wires from the electrical components mounted on
the dash panel. Do not allow wires to touch. See following NOTE.
NOTE: Take care to prevent key switch terminals and wires from touching the metal frame around the dash.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
24
Page 24-1