Table of Contents
Advertisement
13
Fuse
FUSE
See General Warning on page 1-1.
TESTING THE FUSE
See Test Procedure 2 – Fuse on page 11-12.
FUSE REMOVAL
1.
Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL position.
Chock the wheels.
2.
Disconnect battery. See Disconnecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
3.
Remove the air intake hose from the carburetor.
4.
Remove electrical component box cover.
5.
Remove the fuse from the fuse block.
FUSE INSTALLATION
1.
Install the fuse. See following WARNING.
WARNING
• If a fuse is blown, determine the cause of the failure and make necessary repairs before installing a
new fuse. Use the appropriately rated fuse; if a fuse with a higher amp rating is used, damage to the
vehicle electrical system may occur.
2.
Install the snap-on electrical box cover by firmly pressing down on all corners and install the screw and tighten to
18 in-lb (2 N·m).
3.
Install the air intake hose onto the carburetor.
4.
Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
Page 13-20
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
ELECTRICAL COMPONENTS: KEY-START WITH
NEUTRAL REV GAS VEHICLE
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
