Intake Duct Installation - Club Car Turf 252 2007 Maintenance And Service Manual

17
Choke and Air Intake System
8. Lift air box assembly off the intake duct. Be careful that the intake seal on the bottom of the air box assembly is
not dislodged in the process.
9. Pull the intake duct forward and out of the vehicle.

INTAKE DUCT INSTALLATION

The intake duct assembly is installed from the front of the vehicle.
1. Slide the intake duct between the round crossmember and the floorboard, moving it to the rear along the underside
of the floorboard. Insert the end of the intake duct through the slot in the front of the air box mounting plate.
2. Secure the front of the duct to the underside of the floorboard with two pop rivets (25) and flat washers (26)
(Figure 17-12, Page 17-15).
3. Install the air duct shield (30).
3.1. Remove any old double-sided tape that may still be adhered to the air duct shield or frame.
3.2. Place a new strip of double-sided tape on the air duct shield. Do not remove backing from exposed side of
tape.
3.3. Secure the bottom of the air duct shield to the floorboard with a rivet (31).
3.4. Remove the backing from the tape and secure top of air duct shield to frame.
4. Install air box. See Air Box Installation on page 17-13.
5. Install steering joint assembly. See following NOTE.
NOTE: Make sure steering wheel and front wheels are properly aligned before installing steering joint.
5.1. Position steering joint assembly (1) on vehicle as shown. Install three lock washers and three bolts and
tighten to 15 ft-lb (20.3 N·m) (Figure 17-11, Page 17-13).
5.2. Align the flat portion of the steering shaft spline with the bolt hole in the universal joint and then slide
the shaft into the upper universal joint. Install the bolt and lock washer on the upper universal joint and
tighten to 15 ft-lb (20 N·m).
6. Install front left wheel. Tighten the wheel rim mounting nuts. See Wheel Installation, Section 8, Page 8-1.
7. Install front body.
8. Check for proper operation.
Page 17-14 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
S10 FE 350 FUEL SYSTEM