Disconnecting The Batteries - Electric Vehicles; Connecting The Batteries - Electric Vehicles - Club Car Turf 252 2007 Maintenance And Service Manual

1
General Warning
(Viewed from passenger side of vehicle)
1. Remove negative battery cable.
2. Remove positive battery cable.
Connect battery cables in reverse order.
1
Figure 1-1 Gasoline Vehicle
DISCONNECTING THE BATTERIES – ELECTRIC VEHICLES
1. Disable the vehicle. See Disabling the Vehicle on page 1-3.
2. Place Tow/Run switch in the TOW position before disconnecting or connecting the batteries. Failure to heed
this warning could result in a battery explosion or severe personal injury.
3. Disconnect the batteries, negative (–) cable first, as shown (Figure 1-2, Page 1-4).
4. After disconnecting the batteries, wait 90 seconds for the controller capacitors to discharge.
CONNECTING THE BATTERIES – ELECTRIC VEHICLES
CAUTION
• IQ Plus vehicles only: Use only 4-gauge (AWG) with low resistance terminals to replace battery wires.
1. Ensure the Tow/Run switch is in the TOW position.
2. Connect the battery cables, positive (+) cable first.
3. Tighten battery terminals to 110 in-lb (12.4 N·m).
4. Coat terminals with Battery Terminal Protector Spray (CCI P/N 1014305) to minimize corrosion.
Page 1-4 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
(–)
(Viewed from driver side of vehicle)
1. Place TOW/RUN Switch in TOW before disconnecting or connecting
battery cables.
2. Remove negative battery cable.
3. Remove positive battery cable.
Connect battery cables in reverse order.
73
Figure 1-2 IQ Plus Electric Vehicle
SAFETY
(+)