Transaxle; Transaxle Removal - Club Car Turf 252 2007 Maintenance And Service Manual

TRANSAXLE (TYPE G): ELECTRIC VEHICLES

TRANSAXLE

See General Warning on page 1-1.

TRANSAXLE REMOVAL

1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2. Place chocks at the front wheels and slightly loosen lug nuts on both rear wheels.
3. Place a floor jack under the transaxle and raise the rear of the vehicle. Position jack stands under the frame
crossmember between the spring mount and the side stringer, just forward of each rear wheel. Lower the vehicle
to let the jack stands support the vehicle (Figure 28-6, Page 28-5). See WARNING "Lift only one end of
the vehicle..." in General Warning on page 1-1.
4. Remove the rear wheels, then thread one lug nut onto a stud on each rear hub. This will keep the brake drums
on the hubs.
5. Remove the bow tie pins (1), brake cable clevis pins (2), and cable retaining E-clips (3). Disconnect the brake
cables (4) (Figure 28-7, Page 28-5).
Figure 28-6 Vehicle Supported on Jack Stands
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
3
5
Figure 28-7 Brake Cables
28
Transaxle
2
4
1
Page 28-5