Table of Contents
Advertisement
24
Tow/Run Switch
5
TOW/RUN SWITCH
See General Warning on page 1-1.
TESTING THE TOW/RUN SWITCH
See Test Procedure 6 – Tow/Run Switch on page 22-16.
TOW/RUN SWITCH REMOVAL
1.
Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2.
Remove Tow/Run switch boot/hex nut (6) (Figure 24-3, Page 24-4).
3.
Remove Tow/Run switch (10) and nut (9) from bracket (5).
4.
Disconnect the two-pin connector (7) and remove switch.
TOW/RUN SWITCH INSTALLATION
1.
Installation is reverse of removal. Make sure groove on switch is aligned with tang on bracket. Tighten Tow/Run
switch boot/hex nut (6) to 16 in-lb (1.8 N·m) (Figure 24-3, Page 24-4).
2.
Connect the batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
Page 24-4
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
6
9
10
Figure 24-3 Tow/Run Switch and Forward/Reverse Rocker Switch
7
11
ELECTRICAL COMPONENTS: ELEC-
TRIC VEHICLES
13
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
