Kill Limit Switch Installation - Club Car Turf 252 2007 Maintenance And Service Manual

ELECTRICAL COMPONENTS: PEDAL-START GAS
VEHICLE
4. Disconnect the two white/black wires and the black wire from the kill limit switch (12).
5. Remove the kill limit switch (12).
9
10
12
11
8
13
15
A
16
21
A. To Voltage Regulator
517
Figure 14-18 Accelerator Starter and Kill Limit Switches

KILL LIMIT SWITCH INSTALLATION

1. Install the kill limit switch (12) onto the two screws (16) (Figure 14-18, Page 14-17).
2. Connect the two white/black wires to the common (COM) terminal and the black wire to the normally open (NO)
terminal of the kill limit switch (12) and place the switch on the mounting screws located in the electrical component
box. Place the accelerator limit switch (11) on the mounting screws located in the electrical component box.
3. Secure the switches using two washers (10) and two nuts (9). Tighten to 5 in-lb (0.6 N·m). See following
CAUTION.
CAUTION
• Do not overtighten the retaining nuts. If the nuts are overtightened, limit switches could be damaged.
4. Press and release the accelerator pedal to make sure that both switches are being activated when the pedal
is released.
5. Install snap-on electrical component box cover (1). Be sure to press down firmly all corners. Install screw (20)
and tighten to 18 in-lb (2 N·m).
6. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
20
1
14
Kill Limit Switch
Page 14-17