Neutral Lockout Limit Switch Installation - Club Car Turf 252 2007 Maintenance And Service Manual

13
Neutral Lockout Limit Switch

NEUTRAL LOCKOUT LIMIT SWITCH INSTALLATION

1. Install the neutral lockout limit switch with two washers and two nuts (Figure 13-20, Page 13-21). Tighten to
5 in-lb (0.6 N·m). Place the Forward/Reverse handle in REVERSE to make sure that both switches actuate.
See following CAUTION.
CAUTION
• Do not overtighten the retaining nuts. If the nuts are overtightened, limit switches could be damaged.
2. Connect wires to neutral lockout limit switch:
– Connect the black wire to common (COM) terminal and the green wire to the normally open (NO) terminal of
the neutral lockout limit switch. See Wiring Diagrams on page 11-7.
3. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
4. Check limit switch operation.
– Place the Forward/Reverse handle in the NEUTRAL position. Make sure everyone is clear of the vehicle. Turn
the key switch to the START position and hold until the engine is running smoothly. Release the key and it will
return to the ON position and the engine should idle. With the Forward/Reverse handle still in the NEUTRAL
position, engine RPM should increase when pressing the accelerator pedal. If the engine speed does not
increase, turn the key switch OFF and readjust the shift linkage.
5. Test drive the vehicle in both forward and reverse to check for proper operation.
Page 13-22 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
ELECTRICAL COMPONENTS: KEY-START WITH
NEUTRAL REV GAS VEHICLE