Table of Contents
Advertisement
ELECTRICAL COMPONENTS: ELECTRIC
VEHICLES
2.
Refer to the wiring diagram to connect the wires to the key switch terminals and tighten the terminal screws to
7 in-lb (0.8 N·m). See Wiring Diagrams, Section 22, Page 22-2. Coat the terminals with Battery Terminal
Protector Spray (CCI P/N 1014305).
3.
Install center dash by reversing removal procedure. Make sure key switch terminals (7) do not touch frame and
that the center dash panel is properly seated and snapped into place (Figure 24-2, Page 24-2).
4.
Connect the batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
FORWARD/REVERSE ROCKER SWITCH
See General Warning on page 1-1.
TESTING THE FORWARD/REVERSE ROCKER SWITCH
See Test Procedure 26 – Forward/Reverse Rocker Switch on page 22-33.
FORWARD/REVERSE ROCKER SWITCH REMOVAL
1.
Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2.
Remove the center dash panel (Figure 24-1, Page 24-2).
3.
Remove the 18-gauge brown, orange, and blue wires from the rocker switch.
4.
Press the locking tabs on each end of switch (11) and push switch out of dash panel.
FORWARD/REVERSE ROCKER SWITCH INSTALLATION
1.
Press the locking tabs on each end of the rocker switch (11) and push switch into dash panel (Figure 24-3,
Page 24-4).
2.
Connect the 18-gauge brown, orange, and blue wires to the rocker switch exactly as shown in the wiring diagram.
See Wiring Diagrams, Section 22, Page 22-2.
3.
Install center dash by reversing removal procedure. Make sure key switch terminals do not touch frame and
that the center dash panel is properly seated and snapped into place.
4.
Connect the batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
5.
Place the Tow/Run switch in the RUN position.
6.
Inspect the vehicle for proper operation:
– Make sure that the vehicle operates in the forward direction when the Forward/Reverse switch is in the
FORWARD position.
– Make sure that the vehicle operates in the reverse direction when the Forward/Reverse switch is in the
REVERSE position. The reverse buzzer will sound as a warning when the Forward/Reverse switch is in
REVERSE.
– Make sure that the vehicle does not operate when the Forward/Reverse switch is in the NEUTRAL position.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
Forward/Reverse Rocker Switch
24
Page 24-3
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
