Multi-Leaf Spring Installation - Club Car Turf 252 2007 Maintenance And Service Manual

REAR SUSPENSION
2
1
1. Position floor jack under hitch bracket or frame.
2. Lifting Position For Standard Turf 1 and Carryall 1
3. Lifting Position For Turf 2 and 252, Carryall 2 and 252, Carryall
2 Plus and XRT 900
4. Lifting Position For Turf 6 And Carryall 6
Figure 9-2 Lift Vehicle

MULTI-LEAF SPRING INSTALLATION

NOTE: When installing rear leaf springs, make sure that both springs have identical part numbers.
1. Install rubber bushings (4) and steel sleeves (3) into leaf spring eyes if bushings were removed (Figure 9-3,
Page 9-4).
2. Place front of leaf spring (12) into vehicle frame and insert bolt (24) through frame and leaf spring eye. Install lock
nut (25) and tighten to 15 ft-lb (20.3 N·m).
3. Align the other end of leaf spring with the holes in the spring shackles (1). Insert bolt (15) through leaf spring
eye and shackles. Install lock nut (2) and tighten to 15 ft-lb (20.3 N·m). Lower transaxle onto leaf spring (12).
See following CAUTION.
CAUTION
• When placing transaxle on spring, be sure to position locating bolt on the spring in the locating hole in
the transaxle saddle (23) (Figure 9-3, Page 9-4).
4. Install shock mount bracket (16) onto locating bolt at bottom center of leaf-spring (Figure 9-3, Page 9-4). See
following NOTE.
4.1. Install U-bolt (11) and lock nuts (14). Tighten U-bolt to 25 ft-lb (34 N·m) (Figure 9-3, Page 9-4).
5. Install shock absorber. See Shock Absorber Installation on page 9-1. See following NOTE.
NOTE: When installing shock absorbers, make sure rear shocks have identical part numbers.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
3
4
9
Multi-Leaf Springs
Page 9-3