Crankcase Cover Installation - Club Car Turf 252 2007 Maintenance And Service Manual

15
Crankcase
2. Position the sensor and bracket on inside of crankcase and install two mounting screws.
3. Connect sensor wire (2) to cord connector (1) (Figure 15-5, Page 15-6).
4. Install screw (3) through wire clamp and into crankcase cover. Tighten to 30 in-lb (3.4 N·m).
1
4
9
528
Figure 15-5 Oil Level Sensor

CRANKCASE COVER INSTALLATION

CAUTION
• Before assembly, make sure parts are clean.
• Do not reuse the gasket. Install a new one.
• Install and tighten crankcase cover bolts as instructed. Failure to do so could cause the cover to
become warped.
1. Clean the gasket surfaces on the crankcase cover to fit a new gasket during installation and inspect the oil seal
for wear and damage.
2. Install crankcase cover. Using HANDS ONLY, seat cover completely against the crankcase. If the cover will not
seat, the camshaft is not installed correctly.
3. Install and finger tighten evenly the eight cover mounting bolts (Figure 15-6, Page 15-7).
4. Tighten the cover mounting bolts in two steps. First, in the sequence shown, tighten all eight bolts to approximately
130 in-lb (14 N·m). Then, repeating the sequence, tighten them to 250 in-lb (28.2 N·m) (Figure 15-6, Page 15-7).
5. Connect the yellow jumper wire (11) to the cord connector (12) (Figure 15-2, Page 15-4).
Page 15-6 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
2
3
7
6
5
8
S10 FE 350 ENGINE