Accelerator Pedal Installation - Gasoline Vehicles - Club Car Turf 252 2007 Maintenance And Service Manual

5
Accelerator Pedal – Gasoline Vehicles
1
5
4
24
25
ACCELERATOR PEDAL INSTALLATION – GASOLINE VEHICLES
1. If the accelerator pivot rod supports were replaced, position the supports (21) on the vehicle frame and install the
four bolts (22), flat washers (19), and lock nuts (18). Finger-tighten nuts at this time (Figure 5-5, Page 5-6).
2. Insert the lower end of the accelerator pedal (1) through the floorboard and install the accelerator pivot rod (6)
through the uppermost hole in the pedal.
3. Install the plastic spacer (20) on the pivot rod (6).
4. Insert the pivot rod through the pivot rod supports on the vehicle frame.
5. Tighten the four bolts (22) attaching the pivot rod supports to the frame to 75 in-lb (8.5 N·m).
6. Install the bolt (4), two washers (5), and a new lock nut (7) through the lower hole in the pedal and through the
pivot rod. Finger-tighten nut at this time.
Page 5-6 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
7
5
10
6
9
8
17
18
19
21
20
21
Figure 5-5 Accelerator Pedal – Gasoline Vehicles
ACCELERATOR AND BRAKE PEDAL GROUP
11
12
13
17
25
24
14
15
16