Reverse Warning Buzzer; Reverse Warning Buzzer Removal; Reverse Warning Buzzer Installation - Club Car Turf 252 2007 Maintenance And Service Manual

ELECTRICAL COMPONENTS: KEY-START WITH
NEUTRAL REV GAS VEHICLE

REVERSE WARNING BUZZER

See General Warning on page 1-1.
TESTING THE REVERSE WARNING BUZZER
See Test Procedure 20 – Reverse Buzzer on page 11-30.

REVERSE WARNING BUZZER REMOVAL

1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL position.
Chock the wheels.
2. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section
1, Page 1-3.
3. Remove the instrument panel. See Key Switch Removal on page 13-17.
4. Disconnect the wires from the reverse warning buzzer (2) (Figure 13-21, Page 13-23).
5. Remove the screw (3), nut (4), lockwasher (5) and flat washer (6) securing the buzzer to the vertical frame support.

REVERSE WARNING BUZZER INSTALLATION

1. Install the screw (3) through the buzzer (2) bracket tab and frame, secure with hardware, and tighten to 14 in-lb
(1.6 N·m) (Figure 13-21, Page 13-23). See following NOTE.
NOTE: The reverse warning buzzer is secured at one hole only.
2. Connect the black wire from the wire harness to the negative (–) terminal on the buzzer.
3. Connect the red/white wire from the wire harness to the positive (+) terminal on the buzzer.
4. Install the dash in reverse order of removal. See Key Switch Removal on page 13-17.
5. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
BLACK GROUND
RED/WHITE
4
5
6
506
Figure 13-21 Front Reverse Warning Buzzer
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
2
3
Reverse Warning Buzzer
Page 13-23
13