Front Brake Cluster Installation; Front Brake Cables; Front Brake Cable Removal - Club Car Turf 252 2007 Maintenance And Service Manual

6

Front Brake Cables

8. Remove hub and bearing assembly from spindle shaft. Remove four bolts (22), cone washers (21), lock washers
(20) and hex nuts (19) that mount the brake assembly to the spindle (Figure 6-18, Page 6-10).
9. Remove brake cluster assembly from spindle.

FRONT BRAKE CLUSTER INSTALLATION

1. Install in reverse order of removal. Use bolts (22), cone washers (21), lock washers (20) and hex nuts (19) to
mount brake assembly (Figure 6-18, Page 6-10).
2. Tighten bolts to 30 ft-lb (41 N·m). Adjust brakes as previously described in this section for the appropriate vehicle.
Use new bow-tie pins when reconnecting brake cables.
FRONT BRAKE CABLES
See General Warning on page 1-1. See also WARNING on page 6-1.

FRONT BRAKE CABLE REMOVAL

1. Remove bow-tie pin (2) and clevis pin (3) from brake lever arm on front brake cluster (Figure 6-21, Page 6-15).
2. Remove E-clip (1) from brake cable housing at the front spindle bracket and remove cable from spindle (Figure
6-21, Page 6-15).
Page 6-14 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
1
11
10
Figure 6-20 Front Spindle Assembly (Four-Wheel Brake Vehicles)
WHEEL BRAKE ASSEMBLIES
2
3
4
9
8
7
5