Information; Iqdm And Iqdm-P Handset Troubleshooting - Club Car Turf 252 2007 Maintenance And Service Manual

IQ DISPLAY MODULE (IQDM) SERIES 2 AND
IQDM-P DIAGNOSTICS
The following faults can be detected within the handset:
CODE NUMBER
9
14
15
16
17
18
Fault History
This menu displays any faults that have been detected within the handset itself.
Clear Fault History
The clear fault history function will erase the history of handset faults that are stored in the handset.

INFORMATION

This menu selection displays information pertaining to the handset. The information provided in this menu selection
includes model number, serial number, the date the handset was manufactured, the handset software version, etc.

IQDM AND IQDM-P HANDSET TROUBLESHOOTING

In the event that the handset does not function as described in this manual, the following troubleshooting guide
should be studied and the referenced test procedures should be performed to troubleshoot the IQDM and IQDM-P
Series 2 handsets.
TROUBLESHOOTING GUIDE
SYMPTOM
Handset display screen is blank
TABLE CONTINUED ON NEXT PAGE
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
TEXT DISPLAYED
Time Out error detect - no response from controller
Communication error with controller
Error in handset
Handset does not support this function
Serial port overrun error
Security lockout on program menu
POSSIBLE CAUSES
Handset cord and/or adaptor is disconnected
Vehicle batteries – loose terminals or corrosion
Vehicle batteries – improperly wired
Vehicle batteries – batteries failed
Vehicle batteries – batteries not fully charged
Handset cord has failed
Handset cord adaptor has failed
IQDM jack (on vehicle) has failed
Contrast Setting is too light
Onboard computer is in power-down mode
IQDM and IQDM-P Handset Troubleshooting
CORRECTIVE ACTION
See Plugging the Handset into the Vehicle
on page 23-1.
See Section 25 – Batteries: Electric Vehicles.
See Section 25 – Batteries: Electric Vehicles.
See Section 25 – Batteries: Electric Vehicles.
See Section 25 – Batteries: Electric Vehicles.
Test Procedure 1 – Handset Cord on page
23-21
Test Procedure 2 – Handset Cord Adaptor on
page 23-21
Test Procedure 3 – IQDM Jacks on page 23-21
See Program on page 23-18.
Drive the vehicle for a short distance and
reconnect the handset to the vehicle.
23
Page 23-19