Drive Belt Removal; Drive Belt Installation - Club Car Turf 252 2007 Maintenance And Service Manual

TORQUE CONVERTER: GASOLINE VEHICLES

DRIVE BELT REMOVAL

1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section
1, Page 1-3.
2. Grasp the belt midway between the drive (2) and driven (1) clutches. Lift upward on the belt to force the sheaves
of the DRIVEN clutch apart, then roll the belt off the DRIVEN clutch by rotating the clutch counterclockwise
(Figure 21-2, Page 21-3). See following CAUTION.
CAUTION
• Make sure fingers are not underneath the belt when rolling the belt off the driven clutch.
3. Remove the belt from the drive clutch.
1
2
594
Figure 21-2 Drive Belt Removal

DRIVE BELT INSTALLATION

1. Position the new belt on the drive clutch, then start the belt over the top of the driven clutch.
2. With the belt started onto the driven clutch, rotate the driven clutch counterclockwise and roll the belt over the
driven clutch sheaves and onto the clutch.
3. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
21
Drive Belt
Page 21-3