Table of Contents
Advertisement
ELECTRICAL COMPONENTS: ELECTRIC
VEHICLES
SOLENOID
See General Warning on page 1-1.
The solenoid is located on the passenger side of the electrical component mounting plate.
TESTING THE SOLENOID
See Test Procedure 3 – Solenoid Activating Coil on page 22-12 and Test Procedure 25 – Solenoid Contacts on
page 22-33.
SOLENOID REMOVAL
1.
Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2.
Remove the speed controller cover. See Removing the Speed Controller Cover on page 24-8.
3.
Disconnect all wires from the solenoid (Figure 24-7, Page 24-10).
4.
Loosen, but do not remove, the two screws (1) that hold the solenoid (2) to the component mounting plate.
5.
Lift the solenoid (2) up and off of the component mounting plate.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
Figure 24-6 Speed Controller Cover
1
2
24
Solenoid
Page 24-9
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
