Brake Assembly Cleaning (Manually-Adjusted Brakes) - Club Car Turf 252 2007 Maintenance And Service Manual

WHEEL BRAKE ASSEMBLIES
CAUTION
• The brake shoes are under spring pressure and can release suddenly when brake shoe retainers are
removed.
Figure 6-3 Rotate Clip Retainer
6. Grasp both brake shoes and pull them, with the springs, out of brake assembly (Figure 6-4, Page 6-3).

BRAKE ASSEMBLY CLEANING (MANUALLY-ADJUSTED BRAKES)

See General Warning on page 1-1. See also WARNING on page 6-1.
1. Carefully clean the brake backing plate and all mechanical components.
2. Remove rubber boot from backing plate and wipe with a clean, damp cloth.
3. Lubricate slide (1) and slide plate (2) with dry moly lubricant (CCI P/N 1012151) on both sides of the backing
plate. After lubricating, work slide back and forth to ensure it slides smoothly and easily (Figure 6-5, Page 6-4).
Reinstall rubber boot onto backing plate. See following WARNING.
WARNING
• Apply grease carefully when performing the following steps. Do not allow any grease to get on the
friction surfaces of the brake shoe pads. Failure to heed this warning could cause diminished brake
performance, possibly resulting in property damage or severe personal injury.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
Brake Assembly Cleaning (Manually-Adjusted Brakes)
2
1
Figure 6-4 Remove Shoes
6
Page 6-3