Section 6 - Wheel Brake Assemblies; General Information; Brake Shoe Removal - Club Car Turf 252 2007 Maintenance And Service Manual

Hide thumbs Also See for Turf 252 2007:
Table of Contents

Advertisement

SECTION 6 – WHEEL BRAKE ASSEMBLIES
DANGER
• See General Warning on page 1-1.
WARNING
• See General Warning on page 1-1.
• Some aftermarket brake shoes contain asbestos fiber, and asbestos dust is created when these brake
mechanisms are handled. Wear approved eye and respiratory protection when disassembling and
cleaning brake mechanisms. Inhalation of asbestos could result in severe personal injury or death. Do
not use compressed air or aerosol sprays to clean the brake mechanism. Clean brake mechanism
using the negative pressure enclosure/hepa vacuum system or low pressure/wet cleaning method per
OSHA/29 CFR - 1910.1001.

GENERAL INFORMATION

The Club Car vehicles covered in this manual are equipped with four-wheel manually-adjusted brakes. See Vehicle
Specifications on page 2-1.

BRAKE SHOE REMOVAL

See General Warning on page 1-1. See also WARNING on page 6-1.
1.
To remove rear brake shoes, place chocks at the front wheels, loosen the rear wheel lug nuts, and lift the rear of
the vehicle with a chain hoist or floor jack. Place jack stands under the axle tubes to support the vehicle.
2.
Release park brake if latched and loosen equalizer retaining nuts (1) on equalizer rod (2) to slightly loosen brake
cable (Figure 6-1, Page 6-2).
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
6
Page 6-1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents