Ignition Coil Inspection And Repair; Ignition Coil Installation; Crankcase Cover Installation; Engine Installation - Club Car Turf 252 2007 Maintenance And Service Manual

S10 FE 350 ENGINE
3
533
Figure 15-11 Fan and Flywheel Installation

IGNITION COIL INSPECTION AND REPAIR

See Ignition Coil, Section 11, Page 11-23.

IGNITION COIL INSTALLATION

1. Installation is the reverse of removal.
2. While tightening the two bolts (6), use a bronze feeler gauge to adjust the ignition coil air gap to 0.012 inch
(0.304 mm) (Figure 15-10, Page 15-8).
3. Tighten the two ignition coil bolts to 30 in-lb (3.4 N·m).

CRANKCASE COVER INSTALLATION

See Crankcase Cover Installation on page 15-6.

ENGINE INSTALLATION

See General Warning on page 1-1.
1. Place engine onto engine mounting plate and tighten the mounting hardware (1, 2 and 5) to 13 ft-lb (17.7 N·m).
Tighten nuts (6) to 17 ft-lb (23.1 N·m) (Figure 15-4, Page 15-5).
2. Install drive clutch. See Drive Clutch Installation on page 21-11.
3. Install drive belt. See Drive Belt Installation on page 21-3.
4. Install muffler. See Muffler Installation on page 19-1.
5. Install starter/generator and belt. See Starter/Generator Installation on page 13-10.
6. Install the powertrain. See Unitized Transaxle Installation on page 20-14.
7. Install oil drain plug in the crankcase and tighten to 20 ft-lb (27.1 N·m). Apply a light film of oil on the seal of
a new oil filter and install the filter on the crankcase. Fill the crankcase to the proper level with the correct
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
1
15
Engine Installation
Page 15-9