Table of Contents
Advertisement
ELECTRICAL COMPONENTS: KEY-START WITH
NEUTRAL REV GAS VEHICLE
HEADLIGHT BULB REMOVAL
1.
Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL position.
Chock the wheels.
2.
Disconnect battery. See Disconnecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
3.
From the front of vehicle, reach under body and turn the wire harness/halogen bulb assembly (4 and 6) clockwise
one-quarter turn (Figure 13-30, Page 13-32).
4.
Remove the wire harness/halogen bulb assembly (4 and 6) from the headlight lens (7).
5.
Lift the retaining tabs on the connector (4) and remove halogen bulb assembly (6).
HEADLIGHT BULB INSTALLATION
NOTE: When handling halogen bulbs, do not touch glass portion of bulb. Oil from finger tips can cause premature
failure of bulb.
1.
Connect wire harness (4) to the halogen bulb assembly (6). The retaining tab should lock onto the halogen bulb
assembly (Figure 13-30, Page 13-32).
2.
From the front of vehicle, reach under body and insert wire harness/halogen bulb assembly (4 and 6) into the
headlight lens (7).
3.
Turn the wire harness/halogen bulb assembly (4 and 6) counterclockwise one-quarter turn.
4.
Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
2
514
Figure 13-31 Voltage Limiter
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
1
515
Figure 13-32 Light Switch
13
Headlights
1
2
Page 13-33
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
