ELECTRICAL COMPONENTS: KEY-START WITH
NEUTRAL REV GAS VEHICLE
492
A
493
Figure 13-8 Bearing Play Inspection
BEARING REMOVAL
1.
Place the wedge attachment tool (CCI P/N 1012812) between the bearing and the armature. Make sure the
wedge attachment tool is supporting the inner race of the bearing. If a press is not available, secure a bearing
puller (CCI P/N 1012811) to the wedge attachment tool and pull the bearing off of the end of the armature shaft.
Support the armature so that it will not drop when the bearing is removed (Figure 13-9, Page 13-6).
2.
Discard the bearings.
3.
Slide the bearing retainer (32) off of the output end of the shaft (Figure 13-7, Page 13-5).
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
Figure 13-7 Armature and Output End Cover Assembly
B
13
Starter/Generator
39
Page 13-5