Flywheel Installation - Club Car Turf 252 2007 Maintenance And Service Manual

S27 FE 350 ENGINE
CAUTION
• The flywheel nut has right-hand threads. Turn it clockwise to tighten, or counterclockwise to loosen.
• Do not damage the fan blades with the strap wrench. Do not place screwdriver or pry bar in the
fan blades.
4. Remove the flywheel with a puller (CCI P/N 1016627).
5. Remove the flywheel key from its groove.
532
Figure 16-11 Flywheel Nut

FLYWHEEL INSTALLATION

1. Insert the flywheel key into the keyway in the crankshaft. Then align the keyway in the flywheel to the key and
push the flywheel and fan assembly onto the crankshaft until it seats. Install flat washer and nut finger tight.
2. Use a strap wrench (3) to keep the flywheel and fan assembly (1) from turning while tightening the flywheel nut to
63 ft-lb (85.4 N·m) (Figure 16-13, Page 16-10). See following CAUTION.
CAUTION
• The flywheel nut has right-hand threads. Turn it clockwise to tighten, or counterclockwise to loosen.
• Be careful not to damage the fan blades. Use a strap wrench to hold flywheel. Do not place screwdriver
or pry bar between fan blades.
3. Install the fan housing and tighten the screws to 90 in-lbs (10 N·m).
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
Ignition Coil and Flywheel
6
0.012 Inch
(0.304 mm)
512
Figure 16-12 Adjust Ignition Coil Air Gap
16
Page 16-9