Disassembly Of The Starter/Generator To Service The Brushes; Brush Inspection And Replacement - Club Car Turf 252 2007 Maintenance And Service Manual

13
Starter/Generator
13
14
A. To Battery Ground Post
486

DISASSEMBLY OF THE STARTER/GENERATOR TO SERVICE THE BRUSHES

1. Remove the two bolts (20) and pull commutator end cover (23) free of starter/generator housing (24) (Figure
13-2, Page 13-2). See following NOTE.
NOTE: Brushes must be removed to avoid damage from commutator removal. Lift the brush springs out of the
notches in the brushes and pull the brushes back from the center of the commutator end cover. The springs
will help prevent them from sliding back towards the center (Figure 13-6, Page 13-4).
2. Remove brush covers (29 and 30), screws (25), lockwashers (26), brush springs (28) and brushes (27) (Figure
13-3, Page 13-2). See following NOTE.
NOTE: To clean and inspect the armature/commutator and the bearings, see Disassembly of the Starter/Generator
to Service the Armature/Commutator on page 13-4.
20
487
Figure 13-2 Commutator End Cover

BRUSH INSPECTION AND REPLACEMENT

1. Visually inspect brushes. Replace brushes that are cracked or severely chipped.
Page 13-2 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
1
F1
12 9
A
Figure 13-1 Starter/Generator Removal
23
24
ELECTRICAL COMPONENTS: KEY-START WITH
2
5
11
10
4
488
Figure 13-3 Brush Covers and Brushes
NEUTRAL REV GAS VEHICLE
7