Reset All Settings - Club Car Turf 252 2007 Maintenance And Service Manual

IQ DISPLAY MODULE (IQDM) SERIES 2 AND
IQDM-P DIAGNOSTICS
All Controller Settings
Set from Programmer.
OK (+)
Figure 23-5 Confirmation Message

RESET ALL SETTINGS

In the event that a mistake was made and one or more changes should not have been made with the handset, the
speed controller settings can be reverted to the original settings from the beginning of the session (when the handset
was plugged into the vehicle). This function is similar to the "undo" command on a PC and will work correctly only
when the handset has not been unplugged and power to the speed controller has not been interrupted.
Resetting All Settings
1. During an active session when the settings need to be returned to the original values (the values that were active
at the beginning of the session), scroll to the functions menu and select.
2. Select settings.
3. Select reset all settings.
4. Press + on the change value button to confirm the operation.
5. The handset will display an "executing..." message for the next few seconds while the controller settings are being
stored in the handset's memory (Figure 23-3, Page 23-15).
6. When the handset is finished resetting the speed controller settings, a confirmation message is displayed (Figure
23-6, Page 23-17).
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
Functions Menu
All Controller Settings
Reset to Original Values.
OK (+)
Figure 23-6 Confirmation Message
23
Page 23-17