6
Rear Brake Cables
2
4
Figure 6-24 Loosen Equalizer Nut
REAR BRAKE CABLE INSTALLATION
1.
Place the cable ends in the equalizer (4) (Figure 6-24, Page 6-18). Route cables through hangers in the same
manner as the ones removed.
2.
At the rear wheel brakes, connect the cables to the brake actuator arms using clevis pins (2) and new bow-tie
pins (1) (Figure 6-25, Page 6-18).
3.
Place cables in cable support bracket (5) and secure with E-clips.
4.
Adjust brakes as described in this section for the appropriate vehicle.
Page 6-18
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
1
3
WHEEL BRAKE ASSEMBLIES
3
5
Figure 6-25 Disconnect Cables at Rear Brakes
2
4
1