Section 14 - Electrical Components: Pedal-Start Gas Vehicle; Starter/Generator; Starter/Generator Removal - Club Car Turf 252 2007 Maintenance And Service Manual

SECTION 14 – ELECTRICAL COMPONENTS: PEDAL-START GAS
VEHICLE
DANGER
• See General Warning on page 1-1.
WARNING
• See General Warning on page 1-1.

STARTER/GENERATOR

See General Warning on page 1-1.
TESTING THE STARTER/GENERATOR
See Test Procedure 8 – Starter/Generator (Starter Function) on page 12-18.
See Test Procedure 10 – Starter/Generator (Generator Function) on page 12-19.

STARTER/GENERATOR REMOVAL

1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section
1, Page 1-3.
2. Place the neutral lockout switch in the MAINTENANCE position. Access the engine compartment by removing
the seat.
3. Disconnect the wires from the starter/generator (1). Mark wires before disconnecting. Loosen the pivot nuts (7)
and bolts (5) (Figure 14-1, Page 14-2).
4. Remove the mounting/adjustment nut (12), washer (9) and bolt (11). Lower the starter/generator and remove
the belt (4) from the pulley (10).
5. Support the starter/generator so that when the pivot bolts are removed the starter/generator will not fall to the
ground. Remove the two pivot nuts (7) and bolts (5) from the mounting bracket.
6. Remove the starter/generator.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
14
Page 14-1