Ignition Coil Installation - Club Car Turf 252 2007 Maintenance And Service Manual

ELECTRICAL COMPONENTS: PEDAL-START GAS
VEHICLE
10
509
Figure 14-27 Fan Housing Removal

IGNITION COIL INSTALLATION

NOTE: If a new ignition coil is being installed, the spark plug cap, gasket, protector tube and grommet must be
removed from the old coil and installed on the new coil. See steps 1 through 8 for procedures to remove
and install these existing parts.
If the existing ignition coil will be remounted, proceed to step 9.
1. Remove the rubber gasket (1) on the plug cap (2) by rolling back the gasket onto the spark plug wire (Figure
14-29, Page 14-27).
2. Remove the cap (2) from the wire by turning the cap counterclockwise three or four revolutions while gently
pulling it off the wire.
1
2
CAP
511
Figure 14-29 Clean Grommet
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
9
6
5
8
3
4
5
7
6
8
12
13
11
510
Figure 14-28 Ignition Coil Removal
6
0.012 Inch
(0.304 mm)
512
Figure 14-30 Mount Ignition Coil Using Feeler Gauge
14
Ignition Coil
10
Page 14-27