Table of Contents
Advertisement
24
Speed controller cover
4.
Remove the two screws from the reverse buzzer. Remove the reverse buzzer from the center dash panel.
REVERSE BUZZER INSTALLATION
1.
Install the reverse buzzer in the reverse order of removal. Tighten screws to 4 in-lb (0.45 N·m).
2.
Connect the batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
SPEED CONTROLLER COVER
REMOVING THE SPEED CONTROLLER COVER
1.
Use a flathead screwdriver to pry up the center pieces of the 3 push rivets (1) and remove the rivets (Figure
24-6, Page 24-9).
2.
Pull the speed controller cover (2) down and away from the component mounting plate.
3.
Lift the curved edges of the speed controller cover out of the slots in the component mounting plate.
INSTALLING THE SPEED CONTROLLER COVER
1.
Place the curved edges on the bottom of the speed controller cover (2) into the slots on the component mounting
plate.
2.
Press the speed controller cover onto the component mounting plate over the speed controller and other
electrical components.
3.
Install the three push rivets (1) (Figure 24-6, Page 24-9).
Page 24-8
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
ELECTRICAL COMPONENTS: ELEC-
TRIC VEHICLES
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
