Measuring Waveform Quality
1. With the test set in FDD Test operating mode, configure the mobile station to generate a 12.2 kbps
reference measurement channel (RMC) uplink signal on the correct frequency while synchronized to the
test set.
2. Press the
Measurement selection
3. Select the Waveform Quality measurement.
4. Press the WWQ Setup (
5. Set the measurement parameters as needed for your measurement situation.
Typical waveform quality results are shown above.
key.
) key.
F1
WCDMA Measurements Using FDD Test Operating Mode
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_man_measurements.fm
427