Agilent Technologies 8960 Series Reference Manual page 304

SETup:WCPower
SETup:WCPower:CONTinuous
Function Sets/queries the trigger arm state for the channel power measurement. The trigger arm state
determines whether the channel power measurement will be made once then stop (0|OFF
(single)), or automatically re-arm upon completion of one measurement and repeat the process
(1|ON (continuous)).
Setting Range: 1|ON|0|OFF
Query Range: 1|0
*RST Setting 0 (off)
Requirements Test Application Revision: A.02.00 and above
Programming Example
OUTPUT 714;"SETUP:WCPOWER:CONTINUOUS OFF
!Sets measurement to single trigger mode.
SETup:WCPower:COUNt[:SNUMber]
Function The setting form of this command performs two functions: (1) sets the number of channel power
measurements to be made in a multi-measurement, and (2) sets the multi-measurement STATe
command to 1 (on).
The query form returns the number of channel power multi-measurements to be made when
multi-measurement state is ON.
Setting Range: 1 to 999
Query Range: 1 to 999
*RST Setting Off (10 when STATe = On)
Requirements Test Application Revision: A.02.00 and above
Programming Example
OUTPUT 714;"SETUP:WCPOWER:COUNT:SNUMBER 5"
!Turns on multi-measurements and sets the number of measurements to 5.
SETup:WCPower:COUNt:NUMBer
Function Sets/queries the number of channel power measurements to be made when the
multi-measurement state is ON.
Setting Range: 1 to 999
Query Range: 1 to 999
*RST Setting 10
Requirements Test Application Revision: A.02.00 and above
Programming Example
OUTPUT 714;"SETUP:WCPOWER:COUNT:NUMBER 5"
!Sets the number of channel power multi-measurements to 5.
304
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_hpib_setup_wcpower.fm
"