Rfgenerator - Agilent Technologies 8960 Series Reference Manual

RFGenerator:OUTPut

:RFGenerator

:OUTPut
"Diagram Conventions" on page 168
RFGenerator:OUTPut[:DESTination]
Function Sets/queries the RF output port destination: RF IN/OUT (IO) or RF OUT ONLY (OUT).
If the correct hardware is not installed when trying to change to the RF OUT ONLY port, the test
set displays the following error: Hardware error; RFIO version does not support RF out
only selection.
The query form will always return a value, regardless of the hardware version.
Setting Range: 292 MHz to 2700 MHz
Resolution: 0.1 Hz
Query Range: 292 MHz to 2700 MHz
Resolution: 0.1 Hz
*RST Setting 851 MHz
Requirements Test Application Revision: A.02.00 and above
Hardware: RF Input/Output module with second RF output connector, modified front panel.
Programming Example
OUTPUT 714;"RFGENERATOR:OUTPUT:DESTINATION OUT"
!Sets the RF generator's output destination to the RF Out Only port.
[:DESTination]
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_hpib_rfgenerator.fm
<sp>[IO|OUT]
? (returns IO|OUT)
RFGenerator: OUTPut
282