Agilent Technologies 8960 Series Reference Manual page 469

Error Message
-271 Macro syntax error
-272 Macro execution error
-273 Illegal macro label
-274 Macro parameter error
-275 Macro definition too long
-276 Macro recursion error
-277 Macro redefinition not allowed
-278 Macro header not found
Description
Indicates that a syntactically legal macro program
data sequence, according to IEEE 488.2, 10.7.2, could
not be executed due to a syntax error within the macro
definition.
Indicates that a syntactically legal macro program
data sequence could not be executed due to some error
in the macro definition, see IEEE 488.2, 10.7.6.3.
Indicates that the macro label was not accepted, it did
not agree with the definition in IEEE 488.2, 10.7.3
Indicates that the macro definition improperly used a
macro parameter placeholder, see IEEE 4882, 10.7.3.
Indicates that a syntactically legal macro program
data sequence could not be executed because the string
of block contents were too long for the device to handle,
IEEE 488.2, 10.7.6.1.
Indicates that a syntactically legal macro program
data sequence count not be executed because it would
be recursive, see IEEE 488.2, 10.7.6.6.
Indicates that redefining an existing macro label, see
IEEE 488.2, 10.7.6.4.
Indicates that a legal macro label in the *GMS?, see
IEEE 488.2, 10.13, could not be executed because the
header was not previously defined.
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_ts_err_msg_neg200.fm
-200 through -299 Error Message Descriptions
469