Agilent Technologies 8960 Series Reference Manual page 277

RFANalyzer:CONTrol:UPLink:FREQuency:AUTO
Function Sets/queries the test set's demodulation signal path tune frequency control mode.
ON = automatic
OFF = manual.
Setting Range: 1|ON|0|OFF
Query Range: 1|0
*RST setting 1 (on)
Requirements Test Application Revision: A.02.00 and above
Programming Example
OUTPUT 714;"RFANALYZER:CONTROL:UPLINK:FREQUENCY:AUTO OFF" !Enables manual control of the
demodulation signal path tune frequency.
RFANalyzer:CW:EXPected:POWer
Function Sets/queries the expected CW receiver input power. This setting is only used when the Operating
Mode is set to CW. (See
Setting Range: -60 dBm to +53 dBm
Query Range: -60 dBm to +53 dBm
*RST setting +13 dBm
Requirements Test Application Revision: A.02.00 and above
Programming Example
OUTPUT 714;"RFANALYZER:CW:EXPECTED:POWER -20"
"CALL[:CELL]:OPERating"
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_hpib_rfanalyzer.fm
.)
RFANalyzer
277