Agilent Technologies 8960 Series Reference Manual page 80

Step 3: Set Measurement Parameters
Generic Measurement Parameters
There are three types of generic measurement parameters:
• Measurement Count (used by most measurements)
Measurement Count State
Measurement Count Number
• Measurement Timeout (used by all measurements)
Measurement Timeout State
Measurement Timeout Time
• Measurement Trigger (used by most measurements)
Trigger Arm (used by all measurements)
Trigger Source (not applicable to analog measurements)
Trigger Delay (not applicable to analog measurements)
Measurement Count Parameters
The measurement count parameters control measurement averaging. The STATe command turns averaging
on or off, and the NUMBer command determines the number of averages. The SNUMber command is a
complex command which allows you to turn averaging on and set the number of averages in one command.
Statistical Measurement Results Parameters
Parameter
Measurement Count
State
Measurement Count
Number
Measurement Count
Number and State
Example 1. Programming Example:
OUTPUT Test_set;"SET:DTXP:COUN 10"
sets the multi-measurement count state to ON and set the number of averages to 10 for the digital transmit
power measurement.
80
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_prog_generic_step3.fm
Command Syntax
SETup:<meas-mnemonic>:COUNt:STATe <ON|1|OFF|0>
SETup:<meas-mnemonic>:COUNt:NUMBer <numeric
value>
SETup:<meas-mnemonic>:COUNt[:SNUMber] <numeric
value>