Related Topics - Agilent Technologies 8960 Series Reference Manual

Front Panel Connectors
DATA
This RJ-45 connector provides front panel access to the rear panel LAN connection. This connector is used for
downloading firmware upgrades, or new test applications into the test set. No other types of communication
are possible with the LAN port.
The the DATA connector on the front panel is connected internally to the ETHERNET TO FRONT PANEL
connector on the rear panel. In order to use the front panel DATA connector, connect the rear panel LAN
PORT, to the rear panel ETHERNET TO FRONT PANEL connector with the LAN jumper cable.
The LAN jumper cable, part number E5515-61160, is supplied with the test set.
DVM
Not functional for this release.
RF IN/OUT
This Type-N connector is the default path for all RF signals out of the test set, and is always used as the RF
input. Refer to the technical specifications for more information. See also "RF OUT ONLY" .
RF OUT ONLY
NOTE This port is usable only with the E1962B and E1963A test applications.
This Type-N connector is an optional path for all RF signals out of the test set. Front panel selection of this
port is provided by the RF Output Port ( ) control on the System Config screen, and by the
F6
RFGenerator:OUTPut[:DESTination] IO/OUT command. The same amplitude offsets and output power
settings are used for either selected port (RF IN/OUT or RF OUT ONLY). Refer to the technical specifications
for more information.

Related Topics

"RFGenerator Subsystem" (RF OUT ONLY control)
"Amplitude Offset" (RF amplitude offsets)
429
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_gen_frontpanel_con.fm